300-815 | The Secret Of Cisco 300-815 Brain Dumps

Actualtests offers free demo for 300-815 exam. "Implementing Cisco Advanced Call Control and Mobility Services (CLACCM)", also known as 300-815 exam, is a Cisco Certification. This set of posts, Passing the Cisco 300-815 exam, will help you answer those questions. The 300-815 Questions & Answers covers all the knowledge points of the real exam. 100% real Cisco 300-815 exams and revised by experts!

Free demo questions for Cisco 300-815 Exam Dumps Below:

NEW QUESTION 1
300-815 dumps exhibit
Refer to the exhibit. Within the North American Numbering Plan, gateways located in Ottawa, Canada and marked as “YOW” are assigned to the Calling Party Transformation CSS NANP_CgPTP, which contains partition NANP_calling_xforms. What is the calling-party number and the numbering type if the calling user +1613-555-1234 dials the number?

  • A. calling number 613-555-1234 and numbering type “subscriber”
  • B. calling number 011-1-613-555-1234 and numbering type “subscriber”
  • C. calling number 011613-555-1234 and numbering type “international”
  • D. calling number 613-555-1234 and numbering type “national”

Answer: D

NEW QUESTION 2
Which two extended capabilities must be configured on dial peers for fast start-to-early media scenarios (H.323 to SIP interworking)? (Choose two.)

  • A. DTMF
  • B. BFCP
  • C. VIDEO
  • D. FAX
  • E. AUDIO

Answer: AB

NEW QUESTION 3
An engineer is configuring a call park feature in Cisco Unified Communications Manager Express. Which command does the engineer use to ensure that the call is reverted to the user after 60 seconds?

  • A. R2(config-ephone-dn)#park reservation-group 60
  • B. R2(config-ephone-dn)#park-slot timeout 60 limit 2 recall alternate 3002
  • C. R2(config-ephone-dn)#park reservation-group 1
  • D. R2(config-ephone-dn)#park-slot timeout 30 limit 2 recall alternate 3002

Answer: B

NEW QUESTION 4
Which IOS command creates a SIP- enabled dial peer?

  • A. voice dial-peer 20 sip
  • B. dial-peer voice 20 voip
  • C. dial-peer voice 20 pots
  • D. dial peer voice 20 sip

Answer: B

NEW QUESTION 5
300-815 dumps exhibit
Refer to the exhibit. Users report that outbound PSTN calls from phones registered to Cisco Unified Communications Manager are not completing. The local service provider in North America has a requirement to receive calls in 10-digit format. The Cisco Unified CM sends the calls to the Cisco Unified Border Element router in a globalized E.164 format. There is an outbound dial peer on Cisco Unified Border Element configured to send the calls to the provider. The dial peer has a voice translation profile applied in the correct direction but an incorrect voice translation rule applied, which is shown in the exhibit. Which rule modified DNIS in the format that the provider is expecting?

  • A. rule 1 /^/+([^1].*)/ /0111/
  • B. rule 1/^+1([2-9]..[2-9]……$)/ /1/
  • C. rule 1 /^([2-9]..[2-9]……$)/ /1/
  • D. rule 1 /^+1([2-9]..[2-9]……$)/ //

Answer: B

NEW QUESTION 6
Cisco SIP IP telephony is implemented on two floors of your company. Afterward, users report intermittent voice issues in calls established between floors. All calls are established, and sometimes they work well, but sometimes there is oneway audio or no audio. You determine that there is a firewall between the floors, and the administrator reports that it is allowing SIP signaling and UDP ports from 20000 to 22000 bidirectionally. What are two possible solutions? (Choose two.)

  • A. Go to the SIP profile assigned to these IP phones in Cisco Unified CM and change the range of media ports to 16384-32767
  • B. Ask the firewall administrator to change the ports to TCP.
  • C. Ask the firewall administrator to change the range of UDP ports to 16384-32767.
  • D. Go to the SIP profile assigned to these IP phones in Cisco Unified CM and change the range of media ports to 20000-22000.
  • E. Go to System Parameters in Cisco Unified Communications Manager and change the range of media ports to 20000-22000.

Answer: AC

NEW QUESTION 7
Where on Cisco Unified Communications Manager do you configure the standard local route group for a group of devices?

  • A. System > Location Info
  • B. Call Routing > Route/Hunt > Local Route Group Names
  • C. System > Device Pool
  • D. Call Routing > Emergency Location > Emergency Location (ELIN) Groups

Answer: B

NEW QUESTION 8
When configuring hunt groups, where do you add the individual directory numbers that will be part of the group?

  • A. route group
  • B. line group
  • C. hunt list
  • D. hunt pilot

Answer: B

NEW QUESTION 9
A company has an SRST gateway running an IOS XE image. The company plans to enable the IPv6 addressing companywide. To enable the IPv6 in a unified SRST gateway to support SIP phones, what are two supported supplementary features for an IPv6 fallback scenario? (Choose two.)

  • A. three-way conference
  • B. secure SIP lines
  • C. T.38 fax relay
  • D. transcoding
  • E. SIP trunk

Answer: AC

NEW QUESTION 10
What is first preference condition matched in a SIP-enabled incoming dial peer?

  • A. incoming uri
  • B. target carrier-id
  • C. answer-address
  • D. incoming called-number

Answer: A

NEW QUESTION 11
When locations-based Call Admission Control denies the call, which two masks can AAR apply when routing the call through the PSTN? (Choose two.)

  • A. AAR destination mask
  • B. called party transform mask
  • C. external phone number mask
  • D. +E.164 alternate number mask
  • E. enterrise alternate number mask

Answer: AC

NEW QUESTION 12
Which call pickup feature allows users to pick up incoming calls in a group that is associated with their own group?

  • A. Other Group Pickup
  • B. BLF Call Pickup
  • C. Group Call Pickup
  • D. Directed Call Pickup

Answer: A

NEW QUESTION 13
In Cisco Unified Communications Manager globalized call routing is implemented and must confirm that it is correctly implemented without making a call. Which tool do you use for verification?

  • A. Dialed Number Analyzer
  • B. Real-Time Monitoring Tool
  • C. SDI trace
  • D. SDL trace

Answer: A

NEW QUESTION 14
A network engineer designs a new dial plan and wants to block a certain range of numbers (8135100 through 8135105). What is the most specific route pattern that can be configured to block only the numbers in this range?

  • A. 813510[012345]
  • B. 813510[12345]
  • C. 813510[^0-5]
  • D. 81XXXXX

Answer: A

NEW QUESTION 15
Which section under the Real-Time Monitoring Tool allows for reviewing the call flow and signaling for a SIP call in real time?

  • A. Analysis Manager > Inventory > Trace File Repositories
  • B. System > Tools > Trace and Log Central
  • C. Voice/Video > Session Trace Log View > Real Time Data
  • D. Voice/Video > Session Trace Log View > Open From Local Disk

Answer: C

NEW QUESTION 16
A user in location X dials an extension at location Y. The call travels through a QoS-enabled WAN network, but the user experiences choppy or clipped audio. What is the cause of this issue?

  • A. missing Call Admission Control
  • B. codec mismatch
  • C. ptime mismatch
  • D. phone class of service issue

Answer: B

NEW QUESTION 17
300-815 dumps exhibit
Refer to the exhibit. Users report that when they dial the emergency number 9911 from any internal phone, it takes a long time to connect with the emergency operator. Which action resolves this issue?

  • A. Adjust the service parameter T302 timet to the desired value.
  • B. Adjust the service parameter T204 timer to the desired value.
  • C. Check the Urgent Priority check box under 9.911 pattern.
  • D. Point the emergency pattern directly to the PSTN gateway.

Answer: C

NEW QUESTION 18
You see the voice register pool 1 command in your Cisco Unified Communications Manager Express configuration. Which configuration is occurring in this section?

  • A. configuration for a single SIP phone
  • B. configuration items common for all SIP phones
  • C. configuration for a pool of SIP phones (similar to device pool on Cisco Unified Communications Manager)
  • D. configuration for SIP registrar service

Answer: C

NEW QUESTION 19
How does an engineer globalize routing for ingress calls coming from the PSTN to internal DNs?

  • A. At the PSTN gateway, put the calling number in PSTN format and the called number in DN format.
  • B. At Cisco Unified CM, put the calling number in E.164 format and the called number in PSTN format.
  • C. At the PSTN gateway, put the calling number in E.164 format and the called number in localized (DN) format.
  • D. At Cisco Unified Communications Manager, put the calling number in E.164 format and the called number in E.164 format.

Answer: B

NEW QUESTION 20
Which two types of authentication are supported for the configuration of Intercluster Lookup Service? (Choose two.)

  • A. TokenID
  • B. username and secret key
  • C. TLS certificates
  • D. passwords
  • E. FQDN of the servers defined in DNS

Answer: CD

NEW QUESTION 21
......

Thanks for reading the newest 300-815 exam dumps! We recommend you to try the PREMIUM Certleader 300-815 dumps in VCE and PDF here: https://www.certleader.com/300-815-dumps.html (0 Q&As Dumps)