350-801 | A Review Of Precise 350-801 Study Guides
It is impossible to pass Cisco 350-801 exam without any help in the short term. Come to Exambible soon and find the most advanced, correct and guaranteed Cisco 350-801 practice questions. You will get a surprising result by our Renew Implementing and Operating Cisco Collaboration Core Technologies practice guides.
Free demo questions for Cisco 350-801 Exam Dumps Below:
NEW QUESTION 1
Regarding SIP integrations with Cisco Unified Communications Manager, if the Cisco Unity Connection is configured to listen for incoming IPv4 and IPv6 traffic, how should the addressing mode be set up in the Cisco Unity Connection?
- A. Set up is not required.
- B. Set up for each group to use IPv4 and IPv6.
- C. Set up media ports for each port group to use IPv4.
- D. Set up IPv4 and IPv6 in Cisco Unified CM.
Answer: B
NEW QUESTION 2
A customer wants a video conference with five Cisco TelePresence IX5000 Series systems. Which media resource is necessary in the design to fully utilize the immersive functions?
- A. Cisco PVDM4-128
- B. software conference bridge on Cisco Unified Communications Manager
- C. Cisco Webex Meetings Server
- D. Cisco Meeting Server
Answer: C
NEW QUESTION 3
Which wildcard must an engineer configure to match a whole domain in SIP route patterns?
- A. .
- B. !
- C. @
- D. *
Answer: D
Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/10_0_1/ccmcfg/CUCM_BK_C95ABA82_00_admin-guide-100/CUCM_BK_C95ABA82_00_admin-guide-100_chapter_0100111.html
NEW QUESTION 4
An engineer configures Cisco Unified Communications Manager to prevent toll fraud. At which two points does the engineer block the pattern in Cisco Unified CM to complete this task? (Choose two.)
- A. route pattern
- B. route group
- C. translation pattern
- D. partition
- E. CSS
Answer: CE
NEW QUESTION 5
On which Cisco Unified Communications Manager nodes can the TFTP service be enabled?
- A. any node
- B. any two nodes
- C. only nodes that have Cisco Unified CM service enabled
- D. any subscriber nodes
Answer: C
Explanation:
You can configure the TFTP service on the first node or a subsequent node, but usually you should configure it on the first node. For small systems, the TFTP server can coexist with a Cisco Unified Communications Manager on the same server.
NEW QUESTION 6
What is a characteristic of video traffic that governs QoS requirements for video?
- A. Video is typically variable bit rate.
- B. Voice and video traffic are different, but they have the same QoS requirements.
- C. Video is typically constant bit rate.
- D. Voice and video traffic are the same, so they have the same QoS requirements.
Answer: B
Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/srnd/collab11/collab11/cac.html
NEW QUESTION 7
What field is configured to change the caller ID information on a SIP route pattern?
- A. Route Partition
- B. Called Party Transformation Mask
- C. Calling Party Transformation Mask
- D. Connected Line ID Presentation
Answer: D
Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/10_0_1/ccmcfg/CUCM_BK_C95ABA82_00_admin-guide-100/CUCM_BK_C95ABA82_00_admin-guide-100_chapter_0100111.pdf
NEW QUESTION 8
Due to provider requirements, outgoing calls from the Enterprise to the PSTN must start with channel 1. Which ISDN command changes the channel selection an IOS to meet this requirement?
- A. isdn bchan-number-order decending
- B. isdn bchan-number-order ascending
- C. isdn protocol-emulate network
- D. isdn incoming-voice voice
Answer: B
NEW QUESTION 9
DRAG DROP
According to the QoS Baseline Model, drag and drop the applications from the left onto the correct Per-Hop Behavior values on the right.
- A. Mastered
- B. Not Mastered
Answer: A
Explanation:
NEW QUESTION 10
Which two types of device are supported by the Bulk Administration Tool? (Choose two.)
- A. H.322 clients
- B. Cisco Unified IP phones (all models)
- C. SIP trunks
- D. H.225 trunks
- E. music on hold servers
Answer: AB
NEW QUESTION 11
Refer to the exhibit.
A call is failing to establish between two SIP Devices The called device answers with this SOP. Which SDP parameter causes this issue?
- A. The payload for G.711ulaw must be 18.
- B. The calling device did not offer a ptime value.
- C. The media stream is set to sendonly.
- D. The RTP port is set to 0.
Answer: D
NEW QUESTION 12
Why would we not include an end user's PC device in a QoS trust boundary?
- A. The end user could incorrectly tag their traffic to bypass firewalls.
- B. The end user may incorrectly tag their traffic to be prioritized over other network traffic.
- C. There is no reason not to include an end user's PC device in a QoS trust boundary.
- D. The end user could incorrectly tag their traffic to advertise their PC as a default gateway.
Answer: B
NEW QUESTION 13
Where is the default for Maximum Session Bit Rate for a region configured?
- A. Service Parameter Configuration
- B. Enterprise Phone Configuration
- C. Enterprise Parameters Configuration
- D. Region Configuration
Answer: A
Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/9_1_1/ccmcfg/CUCM_BK_A34970C5_00_admin-guide-91/CUCM_BK_A34970C5_00_admin-guide-91_chapter_0111.html
NEW QUESTION 14
When a phone is registered over Mobile and Remote Access, where does it register?
- A. Cisco Unified Presence Server
- B. Expressway-E
- C. Cisco Unified Communications Manager
- D. Expressway-C
Answer: B
Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/admin/12_0_1/systemConfig/cucm_b_system-configuration-guide-1201/cucm_b_system-configuration-guide-1201_chapter_01011010.html QUESTION
NEW QUESTION 15
Refer to the exhibit.
Endpoint A calls endpoint B. What is the only audio codec that can be used for the call?
- A. Telephone-event/8000
- B. G7221/16000
- C. PCMA/8000
- D. G722/8000
Answer: B
NEW QUESTION 16
Given the H.323 gateway configuration and using Cisco best practices, how must the called party transformation pattern be configured to ensure that a proper ISDN type of number is set?
- A.
- B. C.
- C.
Answer: C
NEW QUESTION 17
A Cisco TelePresence SX80 suddenly has issues displaying main video to a display over HDMI. Which command can you use from the SX80 admin CLI to check the video output status to the monitor?
- A. xStatus Video Output
- B. xCommand Video Status
- C. xConfiguration Video Output
- D. xStatus HDMI Output
Answer: C
NEW QUESTION 18
Which two functions are provided by Cisco Expressway Series? (Choose two.)
- A. interworking of SIP and H.323
- B. endpoint registration
- C. intercluster extension mobility
- D. voice and video transcoding
- E. voice and video conference
Answer: AD
Explanation:
Reference: https://www.cisco.com/c/dam/en/us/td/docs/voice_ip_comm/expressway/config_guide/X8-11/Cisco-Meeting-Server-2-4-with-Cisco-Expressway-Deployment-Guide_X8-11-4.pdf
NEW QUESTION 19
What is a valid class included in the 8-Class QoS Strategy in a VoIP network?
- A. Assured Forwarding
- B. Broadcast Video
- C. Multimedia Conferencing
- D. Real-Time Interactive
Answer: C
Explanation:
Reference: https://www.ciscopress.com/articles/article.asp?p=2756478&seqNum=8
NEW QUESTION 20
Which Cisco Unified Communications Manager configuration is required for SIP MWI integrations?
- A. Select “Redirecting Diversion Header Delivery - Inbound” on the SIP trunk.
- B. Enable “Accept presence subscription” on the SIP Trunk Security Profile.
- C. Enable “Accept unsolicited notification” on the SIP Trunk Security Profile.
- D. Select “Redirecting Diversion Header Delivery - Outbound” on the SIP trunk.
Answer: A
NEW QUESTION 21
Which command in the MGCP gateway configuration defines the secondary Cisco Unified Communications Manager server?
- A. mgcapp
- B. ccm-manager fallback-mgcp
- C. mgcp call-agent
- D. ccm-manager redundant-host
Answer: B
NEW QUESTION 22
An engineer implements QoS in the enterprise network. Which command can be used to verify the correct classification and marking on a Cisco IOS switch?
- A. show class-map interface GigabitEthernet 1/0/1
- B. show policy-map interface GigabitEthernet 1/0/1
- C. show policy-map
- D. show access-lists
Answer: C
Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/qos_classn/configuration/xe-16/qos-classn-xe-16-book/qos-classn-mrkg-ntwk-trfc-xe.html
NEW QUESTION 23
Which call routing pattern is used for phone numbers that are in the E.164 format?
- A. +.! Route Pattern
- B. +.! Translation Pattern
- C. /+! Route Pattern
- D. +1.[2-9]XX[2-9]XXXXXX Called Party Transformation Pattern
Answer: D
Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/srnd/collab12/collab12/dialplan.html#pgfId-1591747
NEW QUESTION 24
Which description of the function of call handlers in Cisco Unity Connection is true?
- A. They answer calls, take messages, and provide menus of options.
- B. They provide access to a corporate directory by playing an audio list that users and outside callers use to reach users and leave messages.
- C. They collect information from callers by playing a series of questions and recording the answers.
- D. They control outgoing calls by allowing you to specify the numbers that Cisco Unity Connection can dial to transfer calls, notify users of messages, and deliver faxes.
Answer: A
Explanation:
Reference: https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/connection/10x/administration/guide/10xcucsagx/10xcucsag080.html
NEW QUESTION 25
......
100% Valid and Newest Version 350-801 Questions & Answers shared by Dumps-hub.com, Get Full Dumps HERE: https://www.dumps-hub.com/350-801-dumps.html (New 0 Q&As)