H12-211 | The Renovate Guide To H12-211 Exams

NEW QUESTION 1
Which of the following statements regarding Designated Routers in OSPF are correct?(Choose three)

• A. DR is elected by all the routers in the same network segment.
• B. If the priorities of two routers are different, the router with the lower priority will be elected as DR.
• C. If the priorities of two routers are equal, the router with the higher Router ID will be elected as DR.
• D. DR and BDR must be adjacent.

Answer: ACD

NEW QUESTION 2
According to OSI reference model, which layer is responsible for end to end error checking and flow control?

• A. Physical layer
• B. Data link layer
• C. Network layer
• D. Transport layer

Answer: D

NEW QUESTION 3
Which of the following commands can be used to display the routing table on a Quidway router?

• A. display ip path
• B. display ip routing-table
• C. display interface
• D. display current-configuration

Answer: B

NEW QUESTION 4
Two end stations in a point-to-point network perform address resolution. Which of the following statements iscorrect?

• A. The destination address of an ARP request from each station will be a unicast MAC address.
• B. The destination address of an ARP request from each station will be a broadcast IP address.
• C. The destination address of an ARP reply from each station will be a unicast MAC address
• D. The destination address of an ARP reply from each station will be a broadcast MAC address.

Answer: C

NEW QUESTION 5
According to the default value of route preference on the VRP platform, which of the following represent thecorrect sequence for direct route, static route, RIP and OSPF if they are listed from high preference to lowpreference?

• A. Direct, Static, RIP, OSPF
• B. Direct, OSPF, Static, RIP
• C. Direct, OSPF, RIP, Static
• D. Direct, RIP, Static, OSPF

Answer: B

NEW QUESTION 6
Assume that the router has learnt the best route to the same destination by using RIP, OSPF and Static Routerespectively. By default, the Huawei router will select the route learnt via ( ) as the best route.

• A. RIP
• B. OSPF
• C. RIPv2
• D. Static route

Answer: B

NEW QUESTION 7
Refer to the graphic. In order to improve security, the two hosts use IPsec VPN to transmit data. Which IPsecmode and protocol can be used to hide the host’s IP address?(Choose two).

• A. AH
• B. transport mode
• C. tunnel mode
• D. ESP

Answer: CD

NEW QUESTION 8
While inspecting packets in the network, a network administrator discovers a frame with the destination MACaddress of 01-00-5E-A0-B1-C3. What can the administrator determine from this?

• A. The MAC address is a unicast address.
• B. The MAC address is a broadcast address
• C. The MAC address is a multicast address.
• D. The MAC address is incorrect

Answer: C

NEW QUESTION 9
Which of the following regarding Frame Relay DLCI are correct?(Choose three)

• A. DLCI is locally significant
• B. DLCI is allocated by DTE
• C. The range of DLCI value that can be used is from 16-1007
• D. The same DLCI can be configured on different physical interfaces

Answer: ACD

NEW QUESTION 10
The administrator cannot use telnet to manage the AR2200. The administrator is able to verify connectivity tothe router and has been informed that other administrators have no difficulties using telnet. Which statementsdescribe the possible reasons for this problem?(Choose two)

• A. The user’s status has been blocked
• B. The user’s priviledge level has been changed to 0.
• C. The user has been deleted.
• D. The telnet service in the AR2200 router has been disabled.

Answer: AC

NEW QUESTION 11
How is mapping performed on a DTE device in a Frame Relay network?

• A. The local DLCI number is mapped to a remote IP address.
• B. The local IP address is mapped to a remote DLCI number.
• C. The local DLCI number is mapped to a local IP address.
• D. The remote DLCI number is mapped to a remote IP address.

Answer: A

NEW QUESTION 12
Which of the following is abbreviation of VRP?

• A. Versatile Routine Platform
• B. Virtual Routing Platform
• C. Virtual Routing Plane
• D. Versatile Routing Platform

Answer: D

NEW QUESTION 13
Refer to the graphic. RTA is a DTE device connected to a Frame Relay switch, and uses
dynamic addressmapping to establish the PVC. With regards to the configuration, which of the following commands are notnecessary?(Choose two).

• A. [RTA-Serial1/0/1]ip address 172.16.1.1 24
• B. [RTA-Serial1/0/1]link-protocol FR
• C. [RTA-Serial1/0/1]fr interface-type dte
• D. [RTA-Serial1/0/1]fr inarp

Answer: CD

NEW QUESTION 14
Refer to the graphic. In the private network, RTA dynamically assigns a public address from the address poolto hosts without port translation. Host C wishes to access the public network while pool addresses areassigned to Host A and Host B. What will occur as a result?

• A. The first public address will be allocated to Host C, and Host A will be forced offline.
• B. The last public address will be allocated to Host C, and Host B will be forced offline.
• C. Host C will be unable to forward traffic over the public network.
• D. All hosts will have access to the public network through pool address swapping.

Answer: C

NEW QUESTION 15
Interface G0/0/1 on RTA contains a MAC address of 00e0-fc03-aa73 and is configured with the IPv6 address2001::2E0:FCFF:FE03:AA73. Which method is most likely to have been used to configure the interface IPv6address?

• A. DHCPv6
• B. Auto-link
• C. ARP
• D. EUI-64

Answer: D

NEW QUESTION 16
Which of the following parameters must be specified when configuring static mapping for Frame Relaynetwork?(Choose two)

• A. Local DLCI
• B. Remote DLCI
• C. Local network layer protocol address
• D. Remote network layer protocol address

Answer: AD

NEW QUESTION 17
An ARP request is sent by host A to obtain the destination MAC address of host D. Which statement is trueabout regarding the ARP reply?

• A. The destination MAC address of this frame is the MAC address of Switch A.
• B. The destination IP address of this packet is the VLANIF1 IP address of Switch A.
• C. The destination MAC address of this frame is the MAC address of Host A.
• D. The destination IP address of this packet is a broadcast IP address.

Answer: C

NEW QUESTION 18
Refer to the grapic. An administrator has configured RIPv2 on the two routers, following which he implementsthe command silent-interface s0/0/1 on RTA. What effect will this command have on the network? (TwoAnswers)

• A. RTA will continue to learn routes from RTB
• B. RTB will continue to learn routes from RTA
• C. RTA will have no neighbor relationship with RTB
• D. RTB will have no adjacency relationship with RTA

Answer: AD

NEW QUESTION 19
Refer to the graphic. RTA and RTB are running RIPv1. RTA has advertised 10.0.0.0 and 192.168.1.0 to theRIP network. Which routes will exist in the IP routing table of RTB?(Choose two)

• A. 10.0.0.0/8
• B. 192.168.1.1/32
• C. 10.1.12.1/32
• D. 192.168.1.0/24

Answer: CD

NEW QUESTION 20
<Huawei>display startup MainBoard:
Startup system software: sd1:/ar2220-v200r003c00spc200.cc Next startup system software: sd1:/ar2220-v200r003c00spc200.cc Backup system software for next startup: null
Startup saved-configuration file: null Next startup saved-configuration file: null Startup license file: null
Next startup license file: null Startup patch package: null Next startup patch package: null Startup voice-files: null
Next startup voice-files: null
Refer to the display output. Which statement is false?

• A. The current configuration file has not been saved.
• B. The current startup system software is ar2220-v200r003c00spc200.cc
• C. The next startup system software cannot be changed.
• D. The next startup system software can be changed by using the “startup system software<startup-softwarename>.cc” command.

Answer: C

NEW QUESTION 21
A network requires a solution to allow 50 private IP addresses to be translated, however only a single publicaddress is available for use. Which translation method can be used to support this requirement?

• A. Static NAT
• B. Dynamic NAT
• C. Easy-IP
• D. NAPT

Answer: C

NEW QUESTION 22
If PPP authentication fails, which type of packet will be sent to the authenticated peer by the authenticator?

• A. Authenticate-Ack
• B. Authenticate-Nak
• C. Authenticate-Reject
• D. Authenticate-Reply

Answer: B

NEW QUESTION 23
<R2>debugging rip 1
Sep 13 2013 11:07:20.974.1-05:13 R2 RIP/7/DBG: 6: 13414: RIP 1: Receiving v1 response
on
GigabitEthernet0/0/0 from 10.0.12.1 with 1 RTE
Sep 13 2013 11:07:20.974.2-05:13 R2 RIP/7/DBG: 6: 13465: RIP 1: Receive response
from 10.0.12.1 on GigabitEthernet0/0/0
Sep 13 2013 11:07:20.974.3-05:13 R2 RIP/7/DBG: 6: 13476: Packet: Version 1, Cmd
response, Length 24
Sep 13 2013 11:07:20.974.4-05:13 R2 RIP/7/DBG: 6: 13527: Dest 1.0.0.0, Cost 1
Sep 13 2013 11:07:20.974.5-05:13 R2 RIP/7/DBG: 6: 2688: RIP 1: Ignoring packet. This
version is notconfigured.
Refer to the debug output. Following configuration of R2, the administrator discovers that the behavior is not asexpected and performs debugging. Based on the output from the debug, what is the source of the problem?

• A. R2 has configured an ACL to block the route to network 1.0.0.0
• B. R2 has enabled split horizon.
• C. R1 is using authentication, however R2 is not.
• D. R2 is operating using RIPv2, while R1 is using RIPv1.

Answer: D

NEW QUESTION 24
What of the following statements is correct regarding access control list types and ranges?

• A. A basic ACL value ranges from 1000-2999
• B. An advanced ACL value ranges from 3000-4000
• C. A layer 2 ACL value ranges from 4000-4999
• D. An interface ACL value ranges 1000-2000

Answer: C

NEW QUESTION 25
The PPPoE session establishment process can be divided into which stages?(Choose two).

• A. Discovery stage
• B. DHCP stage
• C. PPPoE Session stage
• D. PPP connecting stage.

Answer: AC

NEW QUESTION 26
......