200-125 | how many questions of 200-125 dumps?

Q1. Which command can you enter to configure a local username with an encrypted password and EXEC mode user privileges?

A. Router(config)#username jdone privilege 1 password 7 08314D5D1A48

B. Router(config)#username jdone privilege 1 password 7 PASSWORD1

C. Router(config)#username jdone privilege 15 password 0 08314D5D1A48

D. Router(config)#username jdone privilege 15 password 0 PASSWORD1

Answer: A

Q2. Which device allows users to connect to the network using a single or double radio?

A. access point

B. switch

C. wireless controller

D. firewall

Answer: A

Q3. Refer to the exhibit.

What is the result of setting the no login command?

A. Telnet access is denied.

B. Telnet access requires a new password at the first login.

C. Telnet access requires a new password.

D. no password is required for telnet access.

Answer: D

Q4. Which three statements about DTP are true? (Choose three.)

A. It is enabled by default.

B. It is a universal protocol.

C. It is a proprietary protocol.

D. It is disabled by default.

E. It is a Layer 3-based protocol.

F. It is a Layer 2-based protocol.

Answer: A,C,F

Q5. Which technology allows a large number of private IP addresses to be represented by a smaller number of public IP addresses?

A. NAT

B. NTP

C. RFC 1631

D. RFC 1918

Answer: A

Q6. Which dynamic routing protocol uses only the hop count to determine the best path to a destination?

A. IGRP

B. RIP

C. EIGRP

D. OSPF

Answer: C

Q7. Which two pieces of information are provided by the show controllers serial 0 command? (Choose two.)

A. the type of cable that is connected to the interface.

B. The uptime of the interface

C. the status of the physical layer of the interface

D. the full configuration of the interface

E. the interface's duplex settings

Answer: A,C

Explanation:

Theshow controllercommand provides hardware-related information useful to troubleshoot and diagnose issues with Cisco router interfaces. The Cisco 12000 Series uses a distributed architecture with a central command-line interface (CLI) at the Gigabit Route Processor (GRP) and a local CLI at each line card.

Q8. Which three options are the HSRP states for a router? (Choose three.)

A. initialize

B. learn

C. secondary

D. listen

E. speak

F. primary

Answer: B,D,E

Explanation:

HSRP States

Q9. Which two statements about IPv6 and routing protocols are true? (Choose two.)

A. Link-local addresses are used to form routing adjacencies.

B. OSPFv3 was developed to support IPv6 routing.

C. EIGRP, OSPF, and BGP are the only routing protocols that support IPv6.

D. Loopback addresses are used to form routing adjacencies.

E. EIGRPv3 was developed to support IPv6 routing.

Answer: A,B

Q10. Which technology can enable multiple VLANs to communicate with one another?

A. inter-VLAN routing using a Layer 3 switch

B. inter-VLAN routing using a Layer 2 switch

C. intra-VLAN routing using router on a stick

D. intra-VLAN routing using a Layer 3 switch

Answer: A