N10-007 | CompTIA N10-007 Braindumps 2021

We offers N10-007 Free Practice Questions. "CompTIA Network+ N10-007", also known as N10-007 exam, is a CompTIA Certification. This set of posts, Passing the N10-007 exam with N10-007 Exam Questions, will help you answer those questions. The N10-007 Exam Dumps covers all the knowledge points of the real exam. 100% real N10-007 Exam Questions and revised by experts!

Online CompTIA N10-007 free dumps demo Below:

NEW QUESTION 1
A junior technician is settings up a voice control device so the Chief Executive Officer (CEO) will able to control various things in the office. Of which of the following types of the loT technologies is this an example?

  • A. LAN
  • B. WAN
  • C. SAN
  • D. PAN

Answer: B

NEW QUESTION 2
A technician is sent to a remote office to set up a device to connect to the internet. The company Standard
document requires stateful inspection.
Which of the following should the technician install?

  • A. ROUTER
  • B. Multilayer switch
  • C. Firewall
  • D. Bridge

Answer: C

NEW QUESTION 3
Which of the following mediums is circuit switched?

  • A. PSTN
  • B. ATM
  • C. Frame relay
  • D. MPLS

Answer: A

NEW QUESTION 4
When configuring a wireless access point, Zach, a network administrator, needs to determine the MAC address of a local printer. Which of the following commands would be MOST helpful in determining the MAC address?

  • A. ping
  • B. arp
  • C. route
  • D. dig

Answer: B

NEW QUESTION 5
A network technician is setting up a new router. Since it is exposed to the public, which of the following are the BEST steps the technician should take when setting up this device? (Choose two.)

  • A. Disable unnecessary services.
  • B. Use private IP addresses.
  • C. Allow remote management access.
  • D. Disable the console port.
  • E. Enable encryption.
  • F. Upgrade to the latest firmware.

Answer: AF

NEW QUESTION 6
The Transport Layer of the TCP/IP model corresponds to which of the following layers of the OSI model?

  • A. 1
  • B. 3
  • C. 4
  • D. 5

Answer: C

NEW QUESTION 7
Which of the following media types can carry a standard Ethernet signal for network connectivity?

  • A. USB
  • B. PArallel
  • C. Serial
  • D. CAT6

Answer: D

NEW QUESTION 8
A network administrator wants to increase the confidentiality of the system by hardening the authentication process. Currently, the users log in using usernames and passwords to access the system. Which of the following will increase the authentication factor to three?

  • A. Adding a fingerprint reader to each workstation and providing a RSA authentication token
  • B. Adding a fingerprint reader and retina scanner
  • C. Using a smart card and RSA token
  • D. Enforcing a stronger password policy and using a hand geometry scan

Answer: A

NEW QUESTION 9
Which of the following is networking stand-alone hardware that will permit any WIFI-compliant to connect to a wired network?

  • A. Wireless hub
  • B. Wireless firewall
  • C. Wireless access point
  • D. Wireless bridge

Answer: C

NEW QUESTION 10
A technician is surveying college’s network equipment room and connectivity. Which of the following types of documentation does the technician need perform a detailed site survey? (Select THREE).

  • A. IDF/MDF documentation
  • B. Cable run label documentation
  • C. network configuration documentation
  • D. Performance baseline documentation
  • E. Standard operating procedure documentation
  • F. Change management documentation
  • G. Rack diagram documentation

Answer: ACG

NEW QUESTION 11
The network optimization process used to allow reasonable use of data, voice, and video on the same network infrastructure is called:

  • A. CARP
  • B. QoS
  • C. Traffic shaping.
  • D. Fault tolerance.

Answer: B

NEW QUESTION 12
A single PRI can deliver multiple voice calls simultaneously using which of the following Layer 1 technologies?

  • A. Time division multiplexing
  • B. Analog circuit switching
  • C. CSMA/CD
  • D. Time division spread spectrum

Answer: A

NEW QUESTION 13
A technician is troubleshooting network connectivity issues with a remote host. Which of the following tools would BEST inform the technician of nodes between the client and the remote host? (Choose two.)

  • A. tracert
  • B. ping
  • C. tcpdump
  • D. pathping
  • E. netstat
  • F. nslookup
  • G. route

Answer: AD

NEW QUESTION 14
A network technician is building a network for a small office. The office currently has cable TV and now requires access to the Internet without adding any cabling other than what is already in place. Which of the following solutions should the technician install to meet these requirements?

  • A. DOCSIS modem
  • B. Wireless router
  • C. DSL modem
  • D. Access point

Answer: A

NEW QUESTION 15
A technician is diagnosing an issue with a new T1 connection. The router is configured, the cable is connected, but the T1 is down. To verify the configuration of the router, which of the following tools should the technician use?

  • A. Loopback adapter
  • B. Cable tester
  • C. Tone generator
  • D. Multimeter

Answer: A

NEW QUESTION 16
A technician is connecting a router directly to a PC using the G1/0/1 interface. Without the use of auto-sensing ports, which of the following cables should be used?

  • A. Straight-through
  • B. Console
  • C. Rollover
  • D. Crossover

Answer: D

Recommend!! Get the Full N10-007 dumps in VCE and PDF From 2passeasy, Welcome to Download: https://www.2passeasy.com/dumps/N10-007/ (New 532 Q&As Version)