NS0-592 | All About Refined NS0-592 Questions

NEW QUESTION 1
A new cluster running ONTAP 9.5 has just been installed and you want to create a FlexGroup volume. Which action will accomplish this task?

• A. Use the storage pool create command.
• B. Use the volume create command.
• C. Use the Deploy utility to provision the FlexGroup volume.
• D. Use the volume size command.

Answer: A

NEW QUESTION 2
Click the exhibit button.

Your customer is calling about their MetroCluster environment. They have provided you with the output of the metrocluster interconnect adapter show command.
Referring to the exhibit, which statement is correct?

• A. For all MetroCluster configurations, this is expected output.
• B. The InfiniBand cables should be connected in this configuration.
• C. The InfiniBand interconnect is not used in MetroCluster.
• D. This is a 2-node MetroCluster.

Answer: A

NEW QUESTION 3
Your customer has initiated several volume move commands to redistribute the workload in their 8-node cluster. To verify that this process is not affecting their client access, they were monitoring the network switches that provide client access, but they do not see the network load of the volume move command.
In this scenario, what is the reason for the behavior?

• A. The volume move command uses the HA iWarp interconnect, not the client access switches.
• B. The volume move command uses copy offload protocol, so it does not show up when monitored.
• C. The volume move command uses the intercluster LIFs, not the data LIFs.
• D. The volume move command uses the cluster interconnect switches, not the client access switches.

Answer: B

NEW QUESTION 4
A customer reports that one their SVMs has two default gateways. The customer wants to know whether this behavior is expected or if one of gateways should be deleted.
In this scenario, what do you tell the customer?

• A. The configuration is acceptable if the customer configures different metrics on all defaults routes.
• B. The configuration is acceptable only if both default gateways are in the same subnet.
• C. This situation is a misconfiguration, and the customer should delete one of the default gateways because there can be only gateway for each SVM.
• D. The configuration is acceptabl
• E. The customer can achieve load balancing between the default gateways by setting the same metric on all default routes.

Answer: A

NEW QUESTION 5
A reboot was performed by a watchdog reset on the node. In this scenario, which statement is true?

• A. The service processor no longer responds.
• B. In case of an L1 watchdog event, determine whether a panic message was recorded.
• C. In case of an L2 watchdog event, determine whether a core was dumped.
• D. The wafl_check command should be executed.

Answer: A

NEW QUESTION 6
A customer reports that OnCommand Performance Manager shows that the workload on node-02 in a 4-node cluster has increased to a level that is higher than the threshold. The customer wants to avoid this issue becoming a performance problem.
Which two actions would result in achieving this goal? (Choose two.)

• A. Use the volume move command to move one or more volumes to another aggregate that is owned by another node that is less utilized.
• B. Use the storage aggregate relocation command to offload an aggregate to its partner.
• C. Use the storage aggregate scrub command to verify the parity on the busy aggregates.
• D. Physically move the shelf to another node that is less utilized.

Answer: AD

NEW QUESTION 7
In a 4-node cluster, nodes 1 and 2 are an HA pair, and nodes 3 and 4 are an HA pair. The following error appears in the log.
12/15/2018 15:48:47 node-2CRITICALclam.node.ooq: Node (name=node- 2, ID= 1001) is out of “CLAM quorum” (reason =quorum update).
In this scenario, which two statements are correct? (Choose two.)

• A. All LUNs are offline in the cluster.
• B. All LUNs are online in the cluster.
• C. Node 1 takes over node 2.
• D. Node 2 takes over node 1.

Answer: AC

NEW QUESTION 8
Your customer added a new DS2246 shelf to an existing stack on their FAS8060A system. The customer then noticed that the new shelf’s disks appear with the shelf serial number instead of the shelf ID in the sysconfig -r command output.
What is the reason for this problem?

• A. The SAS is cabled incorrectly.
• B. There is failed IOM module in the new shelf.
• C. The ACP is cabled incorrectly.
• D. The new shelf has the same ID as another shelf.

Answer: A

NEW QUESTION 9
Your customer states that the storage efficiency on their FAS 8200 is far below what they had expected for a VMware NFS datastore. They enabled deduplication three days ago. The job ran every night for only 10-20 minutes, and the space savings now is less than 5%.
What is causing the space savings to be so low?

• A. They have enabled aggregate-level inline data compaction, so the savings are at the aggregate level.
• B. They have enabled aggregate-level inline deduplication, so the savings are at the aggregate level.
• C. They have not enabled volume-level compression.
• D. They have not run a baseline deduplication to scan old data.

Answer: C

NEW QUESTION 10
In a 4-node MetroCluster cluster, both clusters are alerting that the connection to an ATTO bridge is lost.
Which three components should be verified to determine what is causing this problem? (Choose three.)

• A. the SFPs that are connecting the ATTO bridge to the switch
• B. the dark fiber cables between sites
• C. the ATTO bridge
• D. the SFPs in the storage controllers
• E. the fiber cable that is connecting the ATTO bridge to the switch

Answer: ACE

NEW QUESTION 11
Click the exhibit button.

The storage administrator for the company example.com is attempting to join an SVM to their Active Directory as SVM1. The computer account must also be joined to the Secure organizational unit. Attempts to perform this action using the CLI fail with the error message shown in the exhibit. What is the reason for this error?

• A. The requested OU Secure does not exist in the Active Directory and must be created by the Active Directory administrator.
• B. The requested OU Secure has incorrect principal and errored with KRB5KDC_ERR_S_PRINCIPAL_UNKNOWN.
• C. The administrator account password used in vserver cifs create was not entered correctly.
• D. The syntax is incorrect; it should be vserver cifs create -cifs-server svm1 -domain example.com -ou ou=Secure, dc=example, dc=com.

Answer: B

NEW QUESTION 12
The root aggregate on your single-node ONTAP cluster failed. You have the configuration backups saved on your FTP server?
In this scenario, which two steps are part of the recovery procedure? (Choose two.)

• A. Perform a Netboot using the configuration backup.
• B. Create a new aggregate and set its ha_policy option to sfo.
• C. Boot into maintenance mode.
• D. Create a new root aggregate and set its ha_policy option to cfo.

Answer: CD

NEW QUESTION 13
You configured iSCSI multipathing on a Windows host to a 2-node ONTAP cluster so that you can attach to some LUNs. You see that the host logging in to both iSCSI LIFs in the ONTAP cluster, and you notice that the igroup is correctly set. After you open Disk Management and rescan for disks, the NetApp LUNs do not show up.
In this scenario, what should be performed to enable the LUNs to be visible to the Windows host?

• A. Set up LUN mapping and try scanning again.
• B. Configure the SVM for FCP and try scanning again.
• C. Set up Selective LUN Mapping (SLM) and try scanning again.
• D. Configure the ONTAP nodes for HA and try scanning again.

Answer: C

NEW QUESTION 14
At a customer site, the storage failover giveback command fails when giving back the root aggregate. What would be two reasons for this failure? (Choose two.)

• A. There are active NFS connections.
• B. There are failed disks.
• C. The HA interconnect is not operational.
• D. There are active SIS operations running.

Answer: BC

NEW QUESTION 15
Click the exhibit button.

When you log in to a node, a warning is displayed as shown in the exhibit. Which statement is correct in this scenario?

• A. The node root volume was moved to a new aggregate.
• B. The partner still hosts the CFO aggregate for the node.
• C. One or more RDB db files are damaged due to an internal software error.
• D. The node cannot communicate with the rest of the nodes in the cluster.

Answer: D

NEW QUESTION 16
You have a 2-node ONTAP Select HA deployment. In this scenario, which application manages the quorum, if one node fails?

• A. ONTAP Mediator
• B. ONTAP Deploy VM
• C. vCenter Server
• D. Tiebreaker

Answer: B

NEW QUESTION 17
......