1Z0-597 | 10 Tips For Renew 1Z0-597 exam question
Q31. Using the logical domain configuration below, what is the domain and virtual CPU corresponding to physical CPU number 5?
A. domain primary, virtual CPU number 0
B. domain primary, virtual CPU number 1
C. domain ldg2, virtual CPU number 0
D. domain ldg1, virtual CPU number 1
Answer: D
Q32. According to the Enterprise Installation Standards (EIS), what is the minimum amount of time SunVTS should be run?
A. 10 minutes
B. 20 minutes
C. 30 minutes
D. 1 hour
Answer: D
Q33. On SPARC T4-2 server, if the memory riser has four dual-rank DIMMs, its bandwidth is approximately 94% of the possible maximum. If the memory riser has only two dual-rank DIMMs, what is the approximate bandwidth as a percent of the total bandwidth?
A. 29%
B. 35%
C. 41%
D. 47%
Answer: D
Q34. You have printed the partition (slice) information for a disk. What type of label does it have?
A. SMI
B. EFI
C. e2label
D. xfs_admin
Answer: C
Q35. Based on the Enterprise Installation Standards (EIS), why should Oracle Explorer Data Collector be run with the “-i” switch after initial system power-on and setup are complete?
A. To remove confidential customer IP addresses from the Explorer output
B. To provide a baseline of the initial system configuration
C. To collect local Intelligent Platform management Interface (IPMI) data
D. To collect remote Oracle ILOM snapshot data
Answer: C
Q36. When setting up Oracle VM Server for SPARC on a SPARC 14 server, you did not remove unneeded PCIe devices from control (primary) domain. What is the impact?
A. PCIe devices from the control domain can no longer be used in I/O domain.
B. Removing PCIe devices from the control domain for use in I/O domains requires a delayed reconfiguration and a reboot of the control domain.
C. You can no longer migrate guest domains to another physical system by means of the domain migration Feature.
D. There is no impact, as PCIe devices can be dynamically reassigned from the control domain to an I/O domain.
Answer: A
Q37. According to the Enterprise Installation Standards (EIS) on electrical grounding, what is the benefit of additional grounding points?
A. Protect systems by helping to avoid leakage current
B. Allows racks to support either AC or DC
C. Allows a rack to support more than two dedicated circuit feeds for higher redundancy
D. Allows a rack to support more than one UPS system for higher redundancy
Answer: A
Q38. You need to establish a remote secure shell (SSH) connection to Oracle ILOM. How do you
enable SSH during the initial installation of the server?
A. Access Oracle ILOM and set the SSH state property to “enable”.
B. Access Oracle ILOM, generate a new SSH authentication key, and set the SSH state property to “enable”.
C. Access Oracle ILOM and start the SSH server.
D. SSH is enabled by default in Oracle ILOM.
Answer: A
Reference:http://docs.oracle.com/cd/E19745-01/820-7145-11/z400035a1306173.html
Q39. According to Enterprise Installation Standards (EIS), which is recommended when creating virtual disk devices for use in guest domain?
A. Create a new volume from an existing ZFS pool
B. Use file containers
C. Use the file containers and ZFS clones to multiply images
D. Use a disk slice directly
Answer: C
Q40. The runs its own embedded operating system.
A. Logical Domains Manager
B. Oracle ILOM service processor
C. OpenBoot PROM
D. Hardware Management Pack
Answer: B
Reference:http://docs.oracle.com/cd/E18476_01/doc.220/e18478/ilom.htm(ILOM overview, see the para immediately after the bulleted points)