1Z0-597 | Virtual Oracle 1Z0-597 examcollection
Q11. You are troubleshooting an installation and have run Oracle Explorer Data Collector. What should you do with the output?
A. Have it analyzed by the Oracle Risk Analysis Services (ORAS) knowledge engine.
B. Have it analyzed by the Remote Diagnostic Agent (RDA) tool.
C. Review the output and address the identified configuration errors.
D. Calculate the system operational risk (e.g., the chance of the system to go out of service due to a hardware issue.)
Answer: C
Q12. According to the Enterprise Installation Standards (EIS), what is the recommended minimum amount of memory that should be allocated to the control domain?
A. 2 GB
B. 3 GB
C. 4 GB
D. 6 GB
Answer: A
Q13. Activating Auto Service Request (ASR) Assets .
A. Is done on the Asset only
B. Is done on both the Asset and the ASR Manager system
C. Is done on the ASR Manager system only
D. Is done on My Oracle Support only
Answer: D
Reference:http://www.oracle.com/technetwork/systems/asr/overview/index.html(second para)
Q14. When replacing the motherboard, how do you preserve the server’s original host ID and MAC address?
A. Move the System Configuration PROM from the old motherboard to the new motherboard.
B. Back up the service processor configuration details from the old system, and restore on the new system.
C. Move the service processor card from the old system to the new system.
D. For security, it not possible to preserve the server’s host ID and MAC address.
Answer: A
Q15. You have set up several guest domains on a SPARC T4 server. Which operating system(s) are supported in these guest domains?
A. Oracle Solaris only
B. Oracle Linux only
C. Oracle Solaris or Oracle Linux
D. Oracle Solaris, Oracle Linux, and OpenSolaris
Answer: A
Q16. If a fault includes a uuid and sunw-msg-id property, then the fault was detected by which of the following?
A. SunVTS
B. POST
C. Solaris Predictive Self-Healing
D. Oracle ILOM
Answer: C
Reference:http://docs.oracle.com/cd/E19839-01/820-2181-15/820-2181-15.pdf(page 22, see the second row, second column of the table)
Q17. How is I/O access configured for logical domains with no physical I/O access?
A. Configured with virtual I/O devices that communicate with the I/O domain, which is not configured as a service domain
B. Configured with virtual I/O devices that communicate with a service domain
C. Configured with virtual I/O devices that communicate with the root domain
D. Configured with virtual I/O devices that communicate with the control domain
Answer: B
Reference:http://docs.oracle.com/cd/E23120_01/html/821-2854/ldomsmanager.html(see virtual input/output, second para, first sentence)
Q18. During an installation, you have selected two disks to be used for your ZFS root pool. What is the impact?
A. Only single disk configurations are supported for the root pool, so Solaris will use the current boot disk for the root pool.
B. Only single disk configurations are supported during the initial creation of a root pool. Mirrored pools can only be created after the initial installation.
C. A single ZFS volume will be used for the swap area and dump device.
D. A mirrored two disk configuration is set up for the root pool.
Answer: D
Reference:http://docs.oracle.com/cd/E19082-01/817-2271/ggset/index.html(bulleted point #3, second para)
Q19. You plan on creating a RAID volume to mirror the system disks. After you have selected a controller, what fcode command should be run to list the physical drivers on the controller?
A. Show-devs
B. Show-volume
C. Show-children
D. Show-drives
Answer: C
Reference:http://docs.oracle.com/cd/E22985_01/pdf/E22989.pdf(page 23)
Q20. What role should you assign to a user account that limits users to viewing the state of all ILOM configuration properties, or to change their own passwords and session time-out properties?
A. Read only (0)
B. Reset and host control (r)
C. Services (s)
D. User management (u)
Answer: A
Reference:http://www.fujitsu.com/downloads/SPARCE/manuals/sparc-t5e/ilom3.0-concept-en- 01.pdf(page 6)