200-310 | All About Actual 200-310 pdf


P.S. Tested 200-310 vce are available on Google Drive, GET MORE: https://drive.google.com/open?id=1VS0ulGY2kPBljQcTWc9vAueUOjgKSPs-


New Cisco 200-310 Exam Dumps Collection (Question 15 - Question 24)

New Questions 15

Which two features are supported by single wireless controller deployments? (Choose two.)

A. automatic detection and configuration of LWAPPs

B. LWAPP support across multiple floors and buildings

C. automatic detection and configuration of RF parameters

D. Layer 2 and Layer 3 roaming

E. controller redundancy

F. mobility groups

Answer: A,B

New Questions 16

Which two can be used as a branch office WAN solution? (Choose two.)

A. frame relay

B. MPLS

C. Metro Ethernet

D. GPRS

E. dial-up modem

F. 3G USB modems

Answer: B,C

Explanation:

Frame relay is old 'shared' technology today's sites use some flavor or Metro E or MPLS/VPN

New Questions 17

In which phase of PPDIOO are the network requirements identified?

A. Design

B. Plan

C. Prepare

D. Implement

E. Operate

F. Optimize

Answer: B

Explanation:

Plan Phase

The Plan phase identifies the network requirements based on goals, facilities, and user needs. This phase characterizes sites and assesses the network, performs a gap analysis against best-practice architectures, and looks at the operational environment. A project plan is developed to manage the tasks, responsible parties, milestones, and resources to do the design and implementation. The project plan aligns with the scope, cost, and resource parameters established with the original business requirements. This project plan is followed (and updated) during all phases of the cycle.

New Questions 18

Refer to the exhibit.

Which next hop will the router select if given an IP packet with the destination address 19.48.254.3?

A. Router 2

B. Router 1

C. Interface 0

D. Interface 1

Answer: A

New Questions 19

What information should be utilized to identify network applications that are running on an existing network infrastructure?

A. customer information

B. existing documentation

C. traffic analysis

D. external feedback

E. user feedback

Answer: C

New Questions 20

Which two considerations are important when designing the access layer? (Choose two)

A. routing between VLANs

B. HSRP implementation

C. load balancing

D. QoS services

E. port security

Answer: D,E

New Questions 21

In an enterprise Layer 2 switched network, which protocol must be running to enable link redundancy?

A. CDP

B. PaGP

C. LACP

D. STP

Answer: D

New Questions 22

Router A has three feasible successors to the 192.168.1.0/24 network, which are listed here:

Option 1 has a metric of 8123228.

Option 2 has a metric of 2195467. Option 3 has a metric of 8803823.

The variance 4 command was issued on Router A. How many active entries does Router A have in its routing table for the 192.168.1.0/24 network?

A. 0

B. 1

C. 2

D. 3

Answer: C

New Questions 23

A data center is reaching its power and cooling capacity. What two virtualization technologies can address the problem by directly reducing the number of physical devices? (Choose two.)

A. virtual switching systems (VSS)

B. virtual device contexts (VDC)

C. virtual servers

D. virtual routing and forwarding

E. virtual port channels (vPC)

F. virtual LANs

Answer: B,C

New Questions 24

Company ABC has intermittent problems registering site IP phones over the WAN with Cisco Unified CallManager at headquarter. The company hires a network consultant to help implement QoS in its network. Which technique should the consultant use to identify traffic and apple alone that travers the network.

A. policing

B. NBAR

C. priority queuing

D. RSVP

Answer: B

100% Updated Cisco 200-310 Questions & Answers shared by Dumpscollection, Get HERE: http://www.dumpscollection.net/dumps/200-310/ (New 326 Q&As)