300-070 | All About Realistic 300-070 exam

Question No: 4

Which pattern does the route pattern +61278[^-5]59 match?

A. +61278359001

B. +61278459001

C. 278259001

D. +61278259001

E. +612783559001

Answer: D

Question No: 5

After you configure a dial plan to call a particular prefix in the PSTN, you notice that some outbound calls are taking longer than usual (15 seconds) before you hear a connecting tone. What is the likely cause of this issue?

A. The outbound gateway must be configured with the new prefix.

B. The endpoint is choosing the best codec to use.

C. The new prefix is overlapping other route patterns.

D. With some prefixes, this is normal behavior of the PSTN.

Answer: C

Question No: 6

What is the correct path selection for a call that is routed through a Cisco Unified Communications Manager system?

A. Devices -> Route Group -> Route List -> Route Pattern

B. Route List -> Route Pattern -> Route Group -> Devices

C. Route Pattern -> Route List -> Route Group -> Devices

D. Route Group -> Devices -> Route Pattern -> Route List

Answer: C

Question No: 7

By default, what value is voice traffic marked as on a Cisco Catalyst Switch?

A. DSCP CAS6 value 21, Cos 3

B. DSCP AF21 value 46, Cos 5

C. DSCP EF value 46, Cos 7

D. DSCP EF value 46, Cos 5

Answer: D

Question No: 8

An organization has built their video infrastructure to perform ad hoc video calls, but they also need to conduct managed video conference calls. Which hardware component is needed to conduct these calls?

A. VCS-E

B. IOS gateway

C. MCU

D. TelePresence server

Answer: D

Question No: 9

An engineer configures a router with an ISDN PRI connection that only contains two dial peers as follows:

dial-peer voice 10 pots destination-pattern 9T port 0/0/0:23

dial-peer voice 100 voip destination-pattern 45.. session target ipv4:10.2.10.1

When an inbound call is placed from the PSTN to extension 4510, a dial tone is heard. Which additional dial peer is needed to allow the call to terminate directly to the internal number?

A. dial-peer voice 1 pots answer-address .

direct-inward-dial

B. dial-peer voice 1 pots destination-pattern 45.. direct-inward-dial

C. dial-peer voice 1 pots incoming called-number . direct-inward-dial

D. dial-peer voice 1 pots destination-pattern 45.. port 0/0/0:23

direct-inward-dial

Answer: C

Question No: 10

Refer to the exhibit.

A Network Administrator needs to create a SIP route pattern to communicate with

Monterrey's Gateway.

The Administrator does not understand why this is not working properly. Which two statements explain the issue and resolve the problem? (Choose two.)

A. The issue is caused by a failure of communication between the Monterrey's Gateway and CUCM.

B. The Administrator should type the reload command into Monterrey's Gateway.

C. The issue is caused by incorrect protocol integration between Monterrey's Gateway and CUCM.

D. The Administrator needs to set up a SIP trunk between Monterrey's Gateway and CUCM.

Answer: C,D

Question No: 11

What is a route list?

A. a list of locations

B. an ordered list of regions

C. a list of route patterns

D. an ordered list of gateways and trunks

E. an ordered list of route groups

Answer: E

Question No: 12

Which three are functions of Cisco Unified Border Element? (Choose three.)

A. client registration

B. H.323 and SIP interworking

C. Lync interworking

D. transcoding

E. phone proxy

F. mobile and remote access

Answer: B,D,E

Question No: 13

Refer to the exhibit.

Which option is the most highly recommended option to install Cisco TelePresence Conductor on the virtual machine?

A. Thick Provision Eager Zeroed

B. Thick Provision Lazy Zeroed

C. Thick Provision

D. Thin Provision

Answer: B

Explanation: Reference:

http://www.cisco.com/c/dam/en/us/td/docs/telepresence/infrastructure/conductor/install_guide/TelePresence-Conductor-Virtual-Machine-Install-Guide-XC3-0.pdf (page 8)