201 | What Real 201 Simulations Is

NEW QUESTION 1
A BIG-IP Administrator is informed that traffic on Interface 1.1 is expected to increase over the maximum bandwidth capacity on the link. There is a single VLAN on the Interface. What should the 8IG-IP Administrator do to increase the total available bandwidth?

• A. Assign two Interfaces to the VLAN
• B. Set the media speed of Interface 1.1 manually
• C. Create a trunk object with two Interfaces
• D. Increase the MTU on the VLAN using Interface 1.1

Answer: C

NEW QUESTION 2
The current status of a given pool is offline (red). Which condition could explain that state? Assume the descriptions below include all monitors assigned for each scenario.

• A. No monitors are currently assigned to any pool, member or node.
• B. The pool has a monitor assigned to it, and none of the pool members passed the test.
• C. The pool has a monitor assigned to it, and only some of the pool's members passed the test.
• D. A monitor is assigned to all nodes and all nodes have passed the tes
• E. The pool's members have no specific monitor assigned to them.

Answer: B

NEW QUESTION 3
Which Virtual Server type should be used to load balance HTTP traffic to a pool of servers?

• A. Standard
• B. Stateless
• C. Forwarding (IP)
• D. Forwarding (Layer 2)

Answer: A

NEW QUESTION 4
The BIG-IP Administrator needs to perform a BIG-IP device upgrade to the latest version of TMOS. Where can the administrator obtain F5 documentation on upgrade requirements?

• A. AskF5
• B. DevCentral
• C. Bug Tracker
• D. iHealth

Answer: A

NEW QUESTION 5
A BIG-IP Administrator makes a configuration change to a Virtual Server on the Standby device of an HA pair. The HA pair is currently configured with Auto-Sync Enabled. What effect will the change have on the HA pair configuration?

• A. The change will be undone when Auto-Sync propagates the config to the HA pair.
• B. The change will be propagated next time a configuration change is made on the Active device.
• C. The change will be undone next time a configuration change is made on the Active device.
• D. The change will take effect when Auto-Sync propagates the config to the HA pair.

Answer: D

NEW QUESTION 6
Refer to the exhibit.

How long will the persistence record remain in the table?

• A. 180 seconds after the last packet
• B. 180 seconds after the initial table entry
• C. 300 seconds after the initial table entry
• D. 300 seconds after the last packet

Answer: D

NEW QUESTION 7
For a given Virtual Server, the BIG-IP must perform SSL Offload and negotiate secure communication overTLSvl.2only.
What should the BIG-IP Administrator do to meet this requirement?

• A. Configure a custom SSL Profile (Client) and select no TLSvl in the options list
• B. Configure a custom SSL Profile (Client) with a custom TLSV1.2 cipher string
• C. Configure a custom SSL Profile (Server) and select no TLSvl in the options list
• D. Configure a custom SSL Profile (Server) with a custom TLSV1.2 cipher string

Answer: B

Explanation:
no TLSvl only disables TLS1.0, TLS1.1 is still used and does not meet the requirements.

NEW QUESTION 8
Which two statements are true about SNATs? (Choose two.)

• A. SNATs are enabled on all VLANs, by default.
• B. SNATs can be configured within a Profile definition.
• C. SNATs can be configured within a Virtual Server definition.
• D. SNAT's are enabled only on the VLAN where origin traffic arrives, by default.

Answer: AC

NEW QUESTION 9
Interface 1.2 on a BIG-IP VE has a status of UNINITIALIZED. What is the reason for this status?

• A. Interface 1.2 has been added to a trunk.
• B. Interface 1.2 has NOT been assigned to a VLAN.
• C. Interface 1.2 has been disabled.
• D. No default route has been created.

Answer: B

Explanation:
trunk is a portchannel, you need to add a physical interface.

NEW QUESTION 10
A development team needs to apply a software fix and troubleshoot one of its servers. The BIG-IP Administrator needs to immediately remove all connections from the BIG-IP system to the back end server. The BIG-IP Administrator checks the Virtual Server configuration and finds that a persistence profile is assigned to it. What should the 8IG-IP Administrator do to meet this requirement?

• A. Set the pool member to a Forced Offline state and manually delete easting connections through the command line.
• B. Set the pool member to a Forced Offline state.
• C. Set the pool member to a Disabled state.
• D. Set the pool member to a Disabled state and manually delete existing connections through the command line.

Answer: A

NEW QUESTION 11
Assume a client's traffic is being processed only by a NAT; no SNAT or virtual server processing takes place. Also assume that the NAT definition specifies a NAT address and an origin address while all other settings are left at their defaults. If a client were to initiate traffic to the NAT address, what changes, if any, would take place when the BIG-IP processes such packets?

• A. The source address would not change, but the destination address would be translated to the origin address.
• B. The destination address would not change, but the source address would be translated to the origin address.
• C. The source address would not change, but the destination address would be translated to the NAT's address.
• D. The destination address would not change, but the source address would be translated to the NAT's address.

Answer: A

NEW QUESTION 12
What is the status of a pool member when manual resume is enabled and a health check first fails and then passes?

• A. Offline (Disabled)
• B. Offline (Enabled)
• C. Available (Disabled)
• D. Available (Enabled)

Answer: A

NEW QUESTION 13
You need to terminate client SSL traffic at the BIG-IP and also to persist client traffic to the same pool member based on a BIG IP supplied cookie. Which four are profiles that would normally be included in the virtual server's definition? (Choose four.)

• A. TCP
• B. HTTP
• C. HTTPS
• D. ClientSSL
• E. ServerSSL
• F. CookieBased Persistence

Answer: ABDF

NEW QUESTION 14
A site has assigned the ICMP monitor to all nodes and a custom monitor, based on the HTTP template, to a pool of web servers. The HTTP based monitor is working in all cases. The ICMP monitor is failing for 2 of the pool member 5 nodes. All other settings are default. What is the status of the monitor is working in all cases?

• A. All pool members are up since the HTTPbased monitor is successful.
• B. All pool members are down since the ICMPbased monitor is failing in some cases.
• C. The pool members whose nodes are failing the ICMPbased monitor will be marked disabled.
• D. The pool members whose nodes are failing the ICMPbased monitor will be marked unavailable.

Answer: D

NEW QUESTION 15
Users report that traffic is negatively affected every time a BIG-IP device fails over. The traffic becomes stabilized after a few minutes.
What should the BIG-IP Administrator do to reduce the impact of future failovers?

• A. Enable Failover Multicast Configuration
• B. Set up Failover Method to HA Order
• C. Configure MAC Masquerade
• D. Configure a global SNAT Listener

Answer: C

NEW QUESTION 16
Assuming there are open connections through an active system's NAT and a fail over occurs, by default, what happens to those connections?

• A. All open connections will be lost.
• B. All open connections will be maintained.
• C. The "Mirror" option must be chosen on the NAT and the setting synchronized prior to the connection establishment.
• D. Longlived connections such as Telnet and FTP will be maintained while shortlived connections such as HTTP will be lost.
• E. All open connections are lost, but new connections are initiated by the newly active BIG IP, resulting in minimal client downtime.

Answer: B

NEW QUESTION 17
Refer to the exhibit

A connection is being established to IP 1.1.1.1 on port 8080. Which virtual server will handle the connection?

• A. fwd_8080_vs
• B. host_vs
• C. host_ 8080_VS
• D. fwdvs

Answer: B

NEW QUESTION 18
An LTM device has a virtual server mapped to www5f.com with a pool assigned. The objects are defined as follows:
Virtual server. Destination 192.168.245.100.443 netmask 255.255.255.0 Persistence: Source address persistence netmask 255.0.0.0 SNAT:AutoMap
Profiles: HnP/TCP
How should the BIG-IP Administrator modify the persistence profile so that each unique IP address creates a persistence record?

• A. netmask 0.0.0.0
• B. netmask 255.255.255.255
• C. netmask 255.255.0.0
• D. netmask 255.256.255.0

Answer: B

NEW QUESTION 19
......