300-070 | The Up to the minute Guide To 300-070 examcollection

Q2. Callers inform you that they hear a second dial tone after dialing the number 4085550123. Which dial-peer configuration command resolves this issue?

A. answer-address 408555....

B. destination-pattern 91[2-9]..[2-9].....

C. forward-digits all

D. direct-inward-dial

Answer: D

Q3. Refer to the exhibit.

What is the command to place the static IP address by CLI in the Cisco TelePresence MSE 8000?

A. MSE 8050: static 0 10.10.2.13 255.255.255.255 10.10.2.1 200.87.100.10 200.87.100.20.

B. MSE 8050: static 0 10.10.2.13 255.255.255.0 10.10.2.1 200.87.100.10 200.87.100.20.

C. MSE 8050: static 1 10.10.2.13 255.255.255.0 10.10.2.1 200.87.100.10 200.87.100.20.

D. MSE 8050: static ip 0 10.10.2.13 255.255.255.0 10.10.2.1 200.87.100.10 200.87.100.20.

Answer: B

Q4. Where do you configure the region for a group of devices?

A. Common device profile.

B. Device defaults.

C. Common device configuration.

D. Common phone profile.

E. Device pool.

Answer: E

Q5. Which three descriptions are true? (Choose three.)

A. The class of service is a parameter that is used for traffic classification and marking at

Layer 2.

B. The IP precedence is a parameter that is used for traffic classification and marking at Layer 2.

C. The differentiated services code point is a parameter that is used for traffic classification and marking at Layer 2.

D. The class of service is a parameter that is used for traffic classification and marking at Layer 3.

E. The IP precedence is a parameter that is used for traffic classification and marking at Layer 3.

F. The differentiated services code point is a parameter that is used for traffic classification and marking at Layer 3.

Answer: A,E,F

Q6. The Ajax Corporation is designing an IP telephony network using Cisco MCS 7845 Series servers, each one capable of supporting 7500 devices. The design must meet these requirements:

-Be cost-effective

-Support up to 7500 phones

-Provide a minimal level of redundancy

A. Two Cisco Unified Communications Manager servers:1 publisher and TFTP server combined.1 primary subscriber.

B. Three Cisco Unified Communications Manager servers:1 publisher and TFTP server combined.1 primary subscriber.1 backup subscriber.

C. Four Cisco Unified Communications Manager servers:1 publisher.1 TFTP server.1 primary subscriber.1 backup subscriber.

D. Five Cisco Unified Communications Manager servers:1 publisher.1 TFTP server.1 primary subscriber.2 backup subscribers.

Answer: B

Q7. Which of the following simplifies and enhances conference resource management?

A. Cisco Telepresence Server

B. Cisco Telepresence MCU

C. Cisco Telepresence MSE 8000

D. Cisco IOS routers with packet voice/data module (PVDM)

E. Cisco Telepresence Conductor

Answer: E

Q8. Which statement about traffic policing and shaping is true?

A. Shaping limits traffic rates by dropping, re-marking, or transmitting traffic.

B. Policing involves regulating excessive traffic rates by delaying (that is, buffering) traffic.

C. Traffic policing and shaping help regulate bandwidth usage by limiting the amount of traffic.

D. Traffic policing is more suitable for lower-speed links such as Multilink PPP and Frame Relay, as it buffers excess traffic.

Answer: C

Q9. What is the relationship between a Region and a Location?

A. The Region codec parameter is used between a Region and its configured Locations.

B. The Region setting for a Location sets the number of audio and video calls that Location can support.

C. The codec parameter configured in the Region is only used between Regions and Location bandwidth isonly used between Locations.

D. The Region codec parameter is combined with Location bandwidth when communicating with otherRegions.

Answer: C

Q10. When dialing 1234, which rule is matched first?

A. route pattern 1XXX

B. route pattern 12[123]X

C. translation pattern 12[123]X

D. translation pattern 1XXX

E. directory number 12345

Answer: C

Q11. Time-of-day routing in Cisco Unified Communications Manager is configured in which of these ways?

A. by specifying a time schedule on the phone device CSS

B. by specifying a time period on the phone device CSS

C. by specifying a time schedule on the partition that is being used for time-of-day routing

D. by specifying a time period on the partition that is being used for time-of-day routing

E. directly on the route pattern using an explicit timetable

Answer: C

Explanation:

Time-of-Day routing comprises individual time periods that the administrator defines and groups into time schedules. The administrator associates time schedules with a partition. In the Partition Configuration window, the administrator chooses either the time zone of the originating device or any specific time zone for a time schedule.

Link: http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/8_5_1/ccmsys/a03tod.html

Reference: Cisco Unified Communications Manager System Guide Release 8.5(1), page- 177.