300-070 | What Verified 300-070 pdf Is?

Question No: 1

If the route patterns 5XXX, 51XX, 513X and 5134 exist within a call route database, which pattern would be matched if the dialed number was 5324?

A. 5XXX

B. 51XX

C. 513X

D. 5134

Answer: A

Question No: 2

When a call is attempted during a particular time of day, what determines the partitions where calling devices search?

A. time schedules

B. calling periods

C. dial schedules

D. time periods

Answer: A

Question No: 3

Refer to Exhibit:

An engineer is working on a ticket that reports TEL1 cannot call TEL2. These dial peers are configured to route the call between the endpoints.

dial-peer voice 2001voip destination-pattern 2001 session protocol sipv2 session target ipv4:10.1.1.2 incoming called-number . codec g722-64

video codec h264

dtmf-relay rtp-nte sip-notify sip-kpml no vad

dial-peer voice 3001 voip

destination-pattern 3001 session protocol sipv2 session target ipv4:10.3.1.2 incoming called-number . codec g722-64

video codec h264

dtmf-relay rtp-nte sip-notify sip-kpml no vad

While troubleshooting, the engineer discovers that the Cisco Unified Border Element is giving the error u201cSIP/2.0 403 Forbiddenu201d. Which two Cisco Unified Border Element configurations resolve this issue? (Choose two.)

A. voice service voip mode border-element ip address trusted list

ipv4 10.1.1.0 255.255.255.0

ipv4 10.2.1.0 255.255.255.0

allow-connections sip to sip sip

bind control source-interface loopback0 bind media source-interface loopback0

B. voice service voip

no ip address trusted authenticate mode border-element

allow-connections sip to sip sip

bind control source-interface loopback0 bind media source-interface loopback0

C. voice service voip mode border-element ip address trusted list

allow-connections sip to sip

sip

bind control source-interface loopback0 bind media source-interface loopback0

D. voice service voip mode border-element

allow-connections sip to sip sip

bind control source-interface loopback0 bind media source-interface loopback0

E. voice service voip mode border-element ip address trusted list

ipv4 10.1.1.0 255.255 255.0

ipv4 10.3.1.0 255.255.255.0

allow-connections sip to sip sip

bind control source-interface loopback0 bind media source-interface loopback0

Answer: B,E

Question No: 4

Which three CLI commands allow you to verify the correct VoIP dial-peer matching? (Choose three.)

A. debug ccsip messages

B. debug voip ccapi inout

C. debug dialpeer match

D. debug voip dialpeer inout

E. show dialplan number

Answer: B,D,E

Question No: 5

ABC SA de CV is a Company located in New York City and has 3 Branch Offices in Laredo, Bryan, and Houston Texas. The network Administrator has the requirement to configure that all international calls goes out first for Houston Texas, if the GW of Houston goes down then the international call goes out for Bryan Texas and if GW of Bryan goes down, the international call will go out of Laredo Texas. What does the Administrator have

to configure to achieve this requirement?

A. Configure a Route Pattern selecting all possible gateways.

B. Configure a Line Group for international calls selecting the first option GW of Houston, then Bryan and finally Laredo. After this he has to configure a Hunt List for international calls selecting the Line Group for international calls and finally create the Hunt Pilot for International calls selecting the Hunt List created for international calls.

C. Configure a New Partition and New CSS for international calls.

D. Configure a Route Group for international calls selecting the first option GW of Houston, then Bryan and finally Laredo. After this he has to configure a Route List for international calls selecting the Route Group for international calls and finally create the Route Pattern for International calls selecting the Route List created for international calls.

Answer: D

Question No: 6

Which statement about the DiffServ QoS deployment architecture is true?

A. DiffServ does not differentiate traffic types and thus cannot provide service levels.

B. DiffServ architecture differentiates and classifies various types of traffic and provides several levels of service based on that classification.

C. Resource Reservation Protocol is an example of a DiffServ mechanism where each router on the path for packet transmission is informed of the upcoming packet stream.

D. DiffServ architecture provides QoS by assuring treatment for a specific traffic flow.

Answer: B

Question No: 7

Refer to the exhibit.

What is the problem when 237 dials 972551915?

A. The problem is in u201cforward-digits 7u201d; the dial peer should be with u201cforward-digits 9.u201d

B. The problem is in u201cforward-digits 7u201d; the dial peer should be with u201cforward-digits 5.u201d

C. The problem is in u201cforward-digits 7u201d; the dial peer should be with u201cforward-digits 2.u201d

D. The problem is in u201cforward-digits 7u201d; the dial peer should be with u201cforward-digits 8.u201d

Answer: D

Question No: 8

Which two codecs are supported by the Cisco Unified Communications Manager software conferencing media resource? (Choose two.)

A. G.723

B. G.729

C. wideband

D. GSM

E. G.711

Answer: C,E

Question No: 9

You have two groups of managers that need to hold Meet-Me conferences. You want each group to have access to a range of 10 Meet-Me numbers. What are the two best ways to accomplish this? (Choose two.)

A. Create two different partitions and add both groups of 10 Meet-Me conference numbers to the partitions.

B. Ensure that the 10 Meet-Me conference numbers overlap with existing ad hoc conferencing numbers.

C. Create two different groups of Meet-Me conference numbers, add them to the partition, and add the partition to the two manager groups to provide limited access.

D. Create a different partition for each group of managers and assign a set of 10 Meet-Me conference numbers to each.

E. Create two groups of 10 Meet-Me conference numbers that do not overlap with any other number in the numbering plan.

Answer: C,E

Question No: 10

When CUCM is configured with a route pattern, translation transformation, which is matched first when a user dials 914085551212?

A. route pattern

B. translation pattern

C. called-party transformation

D. calling-party transformation

Answer: B

Explanation: Link:

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/8_5_1/ccmcfg/b03txpat.htm l

Route pattern is used to route calls to external entities. The calling and called party numbers resulting from the digit transformations configured in the route pattern and/or route lists are then processed by any Transformation Patterns configured for the devices contained in the chosen Route Group.